Clear Coat For Maple Wood

The main difference is that a clear coat does not alter the color of the wood while a stain does.

Clear coat for maple wood.

The 3 coats will melt into one another and will form a hard clear shell within 24. Follow the oil with a coat or two of shellac. Be sure not to shake the can since it could form bubbles and ruin how the clear coat applies to your piece of maple. A good finish whether a clear coat or a stain gives you a chance to lock out moisture and remove the risk of rot mold or mildew.

Allow each coat to dry for 20 40 minutes at 1 3 mils wet film thickness per coat. Use this guide to learn more about choosing and using polyurethane the toughest of the clear coatings. Apply a coat of finish and then tone the wood by spraying pigment on the dried finish or wiping on a gel stain. For added durability a third coat can be applied.

Always apply a second coat and you may want to repeat the process with a third coat. Related products options. When applying polyurethane finish allow the first coat to dry overnight then sand it lightly with 220 grit sandpaper. For a more durable finish top coat over the shellac with a clear lacquer or polyurethane.

Stir the polyurethane clear coat with a stir stick. Applying a clear finish to wood brings out the wood s natural beauty while sealing and protecting the wood s surface. Oil based polyurethane is an excellent product to use for this purpose. Fruitwood snw stain on hard maple wood.

Start by sanding the surface thoroughly and wiping it down to remove any dust. Open the can of clear coat and use a stir stick to mix it up. Our natural no stain is a clear coat that allows all the natural color grain and character of the wood to show through. Most floors require two to three coats of polyurethane for adequate protection.

After it dries sand lightly. Then remove all the sanding dust and apply a second coat. Most clear finishes are applied with a brush working in the direction of the grain of the wood. Allow to dry for 2 hours allowing for shrinkage and tightening of the films to take place.

Coating wood cabinetry furniture or trim with a clear finish whether you stain it or not gives it richness and depth while protecting it from knocks scrapes and the weather. Another commonly used finishing technique on maple is to apply tung oil or linseed oil after the final sanding. Fine sand the 2nd coat with 400 grit to remove surface defect and apply one more coat. Keep stirring the clear coat until it s thoroughly mixed.

Most projects will be ready for normal use in 24 hours. Even when you seal the maple and apply a stain the color may be more uneven than you d prefer and there s an easy way to remedy that.